DeckDraftDIY plans

How to measure your yard for a deck

You need four measurements. They are the house wall, how far out the deck goes, where the door is, and the height from the door to the ground.

A tape measure and a helper are enough. Write each size down in feet and inches.

Try it free

The four measurements

  1. The house wall. Measure the wall the deck will sit against, end to end. Keep the tape level.
  2. How far out. Decide how far the deck reaches from the wall. Push a stake in the ground at that spot, and measure from the wall to the stake.
  3. The door. Note where the patio door sits along the wall.
  4. The height. Measure straight down from the door sill to the ground.

No tape for the height? Step 3 of the designer asks how you get from the back door to the yard today. It gives an estimate from your answer.

Type them into the designer

Step 1 starts you with a straight 30 ft wall. Tap the green number and type your wall length.

In step 2, pick a size or tap the corners. Then use the Width and Depth boxes. Width is along the house. Depth is out from it.

Sides round to the nearest foot. For an exact size, like 12 ft 7 in, tap the green measurement and type it.

The designer on a phone, step 1: a 30 foot house wall with a green measurement you tap to change
Tap the green number to type the wall length
The designer on a phone, step 2: a 16 by 12 foot deck, with Width, along the house, and Depth, out from the house
Width runs along the house. Depth runs out from it.

Measuring for stairs

Stairs follow the drop from the deck to the ground. Measure it as in the height step above.

The tool works out the number of steps from that drop and the riser height. The riser height is an assumption you can change on the plan page.

Small habits that save trouble

  • Measure each side twice.
  • Measure to the same point each time, such as the outside face of the wall.
  • Sketch the house and deck on paper, and write each size on the sketch.
  • If the wall is not straight, tap Redraw the wall in step 1.

Skip the tape for the house, where lot data exists

If you type your address in a covered area, the designer can draw your lot and your house for you. Coverage is partial. It works in a limited number of areas so far.

Elsewhere, skip that step and measure as above. The site sheet says: “Not a survey. Confirm with your survey.”

Free first

Designing is free, with no account.

Before you pay, you see a free preview: the item names and the first three quantities. The rest shows “Locked”. One payment unlocks the materials list, the cut list and the drawings.

Before you build

Your local building office decides what you need. Check with it before you build.

Questions

Do I need to measure my whole yard?

No. The deck needs the wall it sits against, how far it reaches, the door and the height.

Do the sizes have to be exact?

Start with rough sizes. You can tap any green number later and type the exact one.

What if I do not know the height?

Answer the question in step 3 about how you get from the door to the yard. The designer gives an estimate, and you can set the height yourself.

What if my house wall has a bump or a corner?

Tap Redraw the wall in step 1, or Change the house in step 2, and draw the wall as it is.

Do you build decks or fences?

Put the designers on your website. Each lead arrives with the plan drawing, the measurements and the design, and you do the quoting.

See how it works for builders →

These plans are a design aid, not engineered drawings. Check requirements with your local building department before you build.