Deck board direction and patterns
Boards can run along the house, out from it, or at an angle. They can also make a pattern, like herringbone or chevron.
Each picture below is the same deck, 16 ft along the house and 12 ft out, drawn by the designer. The table shows how many boards each way needs.
Try it freeFive directions
Along the house runs the boards parallel to the house wall. Out from the house runs them from the wall to the yard. The angles turn them 45, 30 or 60 degrees from the wall.





Two patterns
Herringbone boards are cut short and laid in pairs at right angles. Chevron boards meet in a V.


How many boards each way needs
Waste starts at 10%. Angled boards add 5% more, because every board end is cut at a slant. Herringbone and chevron add 10% more.
| How the boards are laid | Boards | Extra waste |
|---|---|---|
| Along the house | 29 | none |
| Out from the house | 38 | none |
| 45° angle | 30 | 5% extra |
| 30° angle | 30 | 5% extra |
| 60° angle | 33 | 5% extra |
| Herringbone | 34 | 10% extra |
| Chevron | 39 | 10% extra |
Boards that run out from the house are shorter, so you buy more pieces for about the same length.
The materials list also changes its framing counts for angled and patterned boards.
Where to set it in the designer
- Go to step 4, Boards and railing.
- Tap Skirting, privacy screen and extras.
- Open Deck look.
- Pick a Board direction and a Board pattern.

Tap 3D to see the deck turn with the boards you picked.
Free first
Designing is free, with no account.
Before you pay, you see a free preview: the item names and the first three quantities. The rest shows “Locked”. One payment unlocks the materials list, the cut list and the drawings.
The site owner sets the price:
Before you build
Your local building office decides what you need. Check with it before you build.
Questions
Does deck board direction matter?
For the look and for how many boards you cut, yes. The table above shows the counts for the same deck each way.
Which direction should I pick?
That is a matter of look. Try each one in the designer and watch the board count change.
Do angled boards need more boards?
Yes, a few more. In the table above, 30 boards at 45° against 29 boards along the house.
Can I see the pattern in 3D?
Yes. Pick the direction or pattern, then tap 3D.
Does the tool show prices?
No. It lists quantities only.
Do you build decks or fences?
Put the designers on your website. Each lead arrives with the plan drawing, the measurements and the design, and you do the quoting.
See how it works for builders →These plans are a design aid, not engineered drawings. Check requirements with your local building department before you build.