DeckDraftDIY plans

Fence on a slope: mark the sloping side first

In the fence designer you can mark a side as sloping. The list then adds a note. The counts stay the same as for level ground.

That means the numbers are a starting point on a slope. Your installer works out what the slope adds.

Try it free

How to mark a slope

  1. Draw your fence, then tap one side.
  2. Under Does this side slope?, pick No, A little or Quite a bit.
  3. Then pick what the fence should do: Step down, or Follow the ground.
Phone screen of the fence designer with one side picked, showing the question Does this side slope and the choices Step down and Follow the ground
A side marked as sloping

You can also say the whole yard slopes. On the Extras step, the designer asks if the yard is sloped where the fence goes. The answers are Flat, A little and Quite a bit.

What the designer records

For a sloping side, the designer records how much it slopes and whether the fence steps down or follows the ground. The list then adds a note. This is the note for a marked side:

“A side is marked as sloping: allow for it. The quantities here are for level ground.”

This is the note when the whole yard is marked:

“The yard slopes a little: allow for it. The quantities here are for level ground.”

The note does not add posts, boards or sections. The table below shows the same 100 ft run five ways.

The same 100 ft fence, with and without a slope
How the slope is markedPostsSectionsBoardsNote added
Level ground1413241No
One side a little sloped, stepped in level sections1413241Yes
One side quite sloped, following the ground1413241Yes
Whole yard a little sloped1413241Yes
Whole yard quite sloped1413241Yes

Every row is counted by the same takeoff. The cut list and the other items are the same in all five rows too.

What to ask your installer

The designer lets you say which you would like. Its own note says: “Your builder picks what suits the product.” Here are questions to bring.

  • Will the fence step down in level sections, or follow the ground?
  • Does the slope change the number of posts, boards or sections?
  • Does the slope change the length of any board or post?
  • What will the sloped sides add to the list?

Free first

Designing is free, with no account.

Before you pay, you see a free preview: the item names and the first three quantities. The rest shows “Locked”. One payment unlocks the materials list, the cut list and the drawings.

Before you build

Your local building office decides what you need. Check with it before you build.

Questions

Does a slope change the counts?

No. The list stays the same as for level ground and adds a note. Your installer works out what the slope adds.

Can I mark just one side as sloping?

Yes. Tap the side and answer Does this side slope? You can also mark the whole yard.

What are the slope choices?

No, A little or Quite a bit for a side. Flat, A little or Quite a bit for the yard. For the fence itself, pick Step down or Follow the ground.

Does the 3D view show the slope?

It shows one gentle slope for the whole yard. A slope on one side is shown on the plan.

What should I tell my installer?

Say which sides slope and how much. Then ask how they will build those sides and what it changes in the count.

Do you build decks or fences?

Put the designers on your website. Each lead arrives with the plan drawing, the measurements and the design, and you do the quoting.

See how it works for builders →

These plans are a design aid, not engineered drawings. Check requirements with your local building department before you build.